Overview of the Intella-Controller

A perfect setup, It has a volt meter so you can keep track of your battery bank voltage, an Amp

meter so you can see what the turbine is producing at any given time. Most controllers with these features cost over to $300 dollars !!

With the Intella-Controller you don't need separate meters and a calculator because it does it all

for you plus more.

It shows you instant readings of battery bank voltage and input amperage, or wattage to the

hundredth, and Amp hour productions, and........... Wait, let's just list the different screens the

Intella-Controller provides so you can see for yourself what it can do for you.

Features available by pressing the MODE or OK buttons:

(1) Generator: Displays the voltage of two of the three phase AC inputs. either A&B, A&C, or

(2) Brake Time: The user adjustable amount of time the turbine is held down in the brake mode.

(in seconds)

(3) Brake On: The user selectable maximum amount of amperage from the turbine before the

brake is applied. (over-speed / storm protection)

(4) User: Displays the actual load in amps placed on the (OUTPUT) terminals when they are

activated by the controller. (max 35.5A)

(5) User On: The user adjustable voltage point that the (OUTPUT) terminals are switched on.

(6) User Off: The user adjustable voltage point that the (OUTPUT) terminals are switched off.

(7) User Ah: The amount of Amp hours that have been consumed through the (OUTPUT)

terminals.

(8) Power: The instant readout of wattage being produced to the hundredth of a watt.

(9) Charge Total: The total amount of Kwh that have been produced.

(10) Charge Ah: The amount of Amp hours produced into your battery bank.

(11) Charge Off: The user adjustable voltage point that the controller stops charging and enters

brake mode.

(12) V / I : The instant readout of the battery bank voltage and Amperage input to your battery

Other features include:

Led status indicator lights BLUE Charging, RED Brake on, and GREEN load output terminal on.

Auto sense of battery type and voltage.

Three Phase AC input direct from your wind turbine... (will not work on DC output turbines like DCPM motors)

Brake switch that you can manually activate to stop your turbine for an extended period of time.

Internal fan for protection against overheat during heavy operation caused by high wind events.